Results for "circulation"

Algae Green Pool Medium 2-3 days 843 👍 8

How Long After Shocking Pool to Add Algaecide? Complete Guide

The pool service guy insists I wait a full 24 hours after shocking before adding algaecide, but that seems excessive when algae keeps spreading. I have two young kids who are eager to get back in the water, and I want to make sure I'm doing this chemical treatment properly.

Should I wait a certain amount of time between the shock treatment and adding the algaecide? I'm also concerned about when the water will be safe for swimming again. What chlorine levels should I be looking for before adding more chemicals, and how do I know when everything is balanced enough for the kids to swim safely?…more

Read answer

Water Chemistry Medium 2-4 days for complete dissolution 797 👍 2

How to Dissolve Pool Stabilizer (CYA) - Complete Guide

Around $800 worth of granular cyanuric acid is just sitting on my pool bottom — would my warranty cover this stabilizer dissolution mess before I drain 20,000 gallons? I have a 20,000 gallon inground pool and my current CYA reading is around 15 ppm - I need to get it up to about 50 ppm. I tried just broadcasting the granules directly into the pool like I do with other chemicals, but they seem to just sink to the bottom and sit there without dissolving much.

I've heard that cyanuric acid is notoriously slow to dissolve compared to other pool chemicals. What's the most effective method to get this stuff into solution? Should I be pre-dissolving it somehow, or is there a specific technique that works better? I want to make sure I'm doing this right and not wasting product or creating hot spots in my pool.…more

Read answer

Above Ground Easy 2-3 hours research and planning 464 👍 0

How Deep Are Above Ground Pools? Complete Depth Guide 2024

Apparently above ground pools only confuse me when it's above 85 degrees outside — why do the depths vary so wildly when I'm actually trying to use one?

My analysis requires accurate data on the typical depth ranges available in the market, as well as identification of the most commonly selected depth configuration.

Additionally, I need to understand the technical factors that influence depth selection decisions. What are the primary considerations that determine optimal depth requirements for different installation scenarios? I'm looking for methodical guidance that addresses both standard measurements and the engineering rationale behind depth selection criteria.…more

Read answer

Product Ranking 8 compared

Best Pool Lights

4.5 (19,800 reviews)

Pump Problems Medium Professional installation required 463 👍 0

Can You Run a Pool Pump on Extension Cord? Safety Guide

After planning our pool party for this Saturday, I discovered my pump outlet is nowhere near the pool equipment pad and I'm scrambling for solutions. The pool store wants me to hire an electrician to install a dedicated circuit for my new pump, but they're quoting me over $800 just for the electrical work. That's on top of what I already spent on the pump itself!

Can I just run a heavy-duty extension cord from my garage outlet to save some money? I've got a 12-gauge outdoor cord that should handle the load. I'm trying to avoid another expensive "professional installation" if I can help it - seems like everything pool-related has to be done by a specialist these days.…more

Read answer

Salt Water Medium 8-24 hours 447 👍 0

Should I Turn Off Salt Cell When Shocking Pool? Expert Guide

Staring at my salt cell wondering if I need to turn it off before shocking my pool — can't afford a $200 service call right now.

Should the salt chlorine generator be turned off while administering shock treatment, or can it continue running?

I want to ensure I'm following correct procedures to avoid any potential equipment damage or interference with the shock's effectiveness. What's the standard protocol for salt cell operation during chemical shock applications?…more

Read answer

Water Chemistry Medium 2-3 days 398 👍 0

How to Fix Pool Stabilizer Level: Complete CYA Guide

Nobody warned me I'd walk out this morning to find my pool showing a 28 ppm CYA reading that has me completely baffled about what to do next.

For low stabilizer situations, what's the exact amount of cyanuric acid needed per gallon of pool water to achieve specific ppm increases? Additionally, I've read that high CYA levels present different challenges - what are the recommended approaches when levels exceed acceptable thresholds? I need reliable technical guidance for both scenarios to maintain proper water chemistry balance.…more

Read answer

Maintenance Medium varies by closure type 337 👍 0

How Long Can a Pool Stay Closed? Duration & Safety Limits

Between the winter thaw and spring opening every year, I'm left wondering if my pool's been closed too long and the water is now unsafe. My facility requires extended closure periods for various operational reasons, and I want to establish clear protocols for both planned seasonal shutdowns and emergency closures.

Specifically, I'm looking for data on maximum safe closure timeframes before water chemistry becomes unmanageable and equipment integrity is compromised. What are the industry standards for winterized pools versus temporary emergency closures?…more

Read answer

Filters Medium 30 minutes 312 👍 0

How Long to Run Pool Filter Daily - Complete Guide

Every pool season I feel like an idiot asking this, but I genuinely have no idea how many hours my filter should actually be running daily. My kids swim almost every day during summer, and I want to make sure the water stays clean and safe for them. I've heard different opinions - some neighbors say they run theirs 24/7, while others only run it a few hours.

I'm worried about under-filtering and having bacteria or algae grow, but I also don't want to waste electricity if it's not necessary. Our pool gets heavy use with the kids and their friends, plus we've had some really hot weather lately. What's the right balance for daily filter runtime to keep the water properly clean?…more

Read answer

Water Chemistry Easy 30 minutes 306 👍 0

Can You Shock Pool After Adding Muriatic Acid? Safe Timing

Our 2019 Intex Easy Set just got muriatic acid to lower the pH but now we're wondering if we can shock it right away. I added some muriatic acid to my pool yesterday to bring down the pH (it was reading around 8.2). Now I'm wondering if I can go ahead and shock the pool today or if I need to wait? I don't want to create any dangerous chemical reactions or damage anything. The pool store guy mentioned something about waiting between chemicals but I can't remember exactly what he said. Should I test the water first or just wait a certain amount of time? Thanks for any help - still learning all this pool chemistry stuff!…more

Read answer

Filters Medium 45 minutes 294 👍 0

Can I Clean Pool Filter With Bleach? Safe Methods Explained

Somewhere in my garage looking at this disgusting pool filter with brown sludge and nasty buildup caked all over the pleats, wondering if bleach is safe. Is this actually safe to do?

I have what I think is a cartridge filter (it's the white pleated kind), and I'm worried about damaging it or my pool equipment if I use the wrong cleaning method. The pool store told me about expensive filter cleaners, but I'm wondering if regular bleach from the grocery store would work just as well. Should I dilute it somehow, and are there any types of filters I should avoid using bleach on?…more

Read answer

Water Chemistry Medium 6-8 hours 289 👍 0

Can I Shock Pool After Adding Alkalinity? Timing Guide

Walked out to check my 20,000 gallon inground pool after dosing it with sodium bicarbonate this morning to raise alkalinity from 60 ppm to 100 ppm, and now I'm second-guessing my shocking timeline. My pH was sitting at about 7.2 before I added the alkalinity increaser, but I know adding baking soda can bump up the pH as well.

I'm planning to shock the pool tonight since we've had some heavy swimmer load this week and the water is starting to look a bit cloudy. Should I wait a certain amount of time after adding the alkalinity before I shock? I want to make sure the shock is as effective as possible and I've heard that pH levels can affect how well chlorine works.

My current test results show chlorine at 1.5 ppm, alkalinity should now be around 100 ppm, and I'm not sure what the pH has risen to after adding the sodium bicarbonate earlier today.…more

Read answer

Product Ranking 5 compared

Best Solar Pool Skimmers

4.4 (8,400 reviews)

Pump Problems Easy 15 minutes 289 👍 0

Can You Run Pool Pump Without Filter? Risks & Solutions

Somewhere between my husband questioning why our pool pump is running without a filter cartridge and my growing panic, I'm wondering if I'm actually damaging something. My filter cartridge is completely clogged and I need to replace it, but my kids are asking to swim this afternoon. I'm wondering if I can just run the pump without any filter for a few hours until I can get to the pool store.

I know this probably isn't ideal, but would it cause any serious damage to the pump or create unsafe water conditions? I don't want to risk my children's safety, but I also don't want to damage our equipment if there's a way to manage this temporarily.…more

Read answer

Heaters Medium 2-4 hours 282 👍 0

Do You Need a Pool Heater Bypass? Installation Guide

Before I connect my new pool heater to the system, it's making this weird whistling sound when water flows through and now I'm wondering if a bypass valve would fix it. The manufacturer's documentation mentions bypass considerations, but I need clarity on whether this is mandatory or optional equipment.

Specifically, I'm concerned about maintaining proper flow rates through the heating unit and having the ability to isolate the heater during routine maintenance procedures. What are the technical requirements and operational benefits of incorporating a bypass valve system into the heater plumbing layout?…more

Read answer

Pump Problems Easy 30 minutes 273 👍 0

Can I Turn Pool Pump Off at Night? Complete Owner's Guide

This electric bill is destroying my budget and I can't afford to keep this pool pump running 24/7 — is it safe to shut it off nights?
The pool store told me the pump should run constantly, but my neighbor says he turns his off at night to save on electricity costs.

I'm worried about messing something up since this is all new to me. Is it actually safe to turn the pump off overnight, or will that cause problems with the water? If I can turn it off, how many hours should it still be running each day to keep everything clean and healthy?…more

Read answer

Filters Medium 4-6 hours 273 👍 0

Can You Shock Pool Without Running Filter? Safe Method

Spent years shocking my old above-ground pool without running the filter and it worked perfectly, but now I'm questioning if it's actually safe for this new setup. I need to shock my pool but I'm wondering if I absolutely have to have the filter system running while I do it? The pool store mentioned something about circulation being important, but they weren't super clear about whether that meant the filter specifically or just water movement in general.

I'm trying to figure out if there's a safe way to shock the pool even if my filter isn't running - maybe by brushing or using the return jets? Any guidance would be really appreciated since I don't want to mess this up!…more

Read answer

Loading more Q&A...

You've seen all 310 Q&A articles!